The Operation and Temperature Control of the Tablet Vulcanizer

Tablet sulfur temperature control, vulcanizer is a common mechanical equipment for plastic products factories. Many manufacturers have updated production equipment. Today we will discuss the operation and temperature control instructions of the flat sulfur.

Operation of the tablet vulcanizer:

1. When putting all the molds in the tablet, you must be in the middle, and you must bring gloves when sending the mold to prevent burns.

2. When sticking the mold, open the mold carefully to prevent it from falling.

3. Adjust the pressure gauge according to the size of the mold and the designated pressure of the unit, and prohibit excessive sulfide.

4. It is forbidden to have a backlog of uneven backlog on the tablet.

5. When cutting samples with sulfur plate, protect the rubber plate.

6. The equipment fails and must be processed before power off.

7. When using the mold, pay attention to the light of the mold cavity and the mold to prevent scratches.

8. When the tablet rises, it is forbidden to remove the mold or clean up the debris.

9. Tablet vulcanized devices that exceed the specified temperature are not allowed.

10. When not in use, cut off the power, reduce the pressure, and turn off the oil valve.

The above ten o'clock is the operation of the tablet vulcanizer. I hope it will be helpful to everyone.

Tablet sulfur temperature control instructions.

1. The temperature control of the tablet vulcanizer is that the temperature controller controls the temperature of the upper, middle, and lower heating plates in the process of vulcanization, to display the panel to display the detection results and set temperature of the heating plate temperature.

Second, during the temperature of the mold of the tablet sulfur, the red light was on. When the working temperature was reached, the alarm light turned green. If the temperature of the mold changes during the production process of the sulfide, the sound and light alarm start, and the machine tool is automatically removed.

3. During the work process, when the mold temperature and the machine tool temperature are controlled by dual -closed loop, the mold temperature is always in high precision control to ensure the improvement and realization of the production process, and the closed loop outside the working cycle will be lifted.